Help & Troubleshooting
Home Service & Support Help & Troubleshooting

Question The faucet leaking. -

Answer

Reason 1:Confirm the water faucet

Solution 1:

1.The new hose-sets supplied with the appliance are to be used and that old hose-sets should not be reused.

2.It is required that the front end shall be longer than 10mm.

3.The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage.

 

Reason 2:Connection between the water inlet hose jointer and the water faucet

Solution 2:

1.Press the lower end of the lock lever  and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1.

2.Take off the nameplate. Make sure the treading is 4mm above the upper surface of the nut. See to Figure 6. If the threading is less than 4mm above the upper surface of the nut. Please loosen the screws.

3.Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet. See to Figure 2. (If the faucet is too large and the joiner can not be set on the water faucet, please loosen the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth, otherwise it may leak water, See to Figure 3. )

4.Fasten the four screws evenly. See to Figure 4.

5.Twist the fastening nut, See to Figure 5. After installation, the threading is less than 2mm above the upper surface of the nut. See to Figure 6.

Related Models:
HWM60-12699NZP
Content Feedback
* 1. Is this content useful ?
* 2. Please evaluate this content ?

3. Please give us some suggestion.

SUBMIT
Product guide

Need your product manual or software? You can find them here!
Service request registration

One step,our door to door service standby.

Email Us


info@haier.com.pk

Send email now

Hotline


Universal Access Number:

(042) 1111 42437 (Haier)

Service Time:9:30am-6:30pm (From Monday to Sunday)