Help & Troubleshooting
Home Service & Support Help & Troubleshooting

Question: How to carry out Self test model for CFE633CW?

Answer:

TEST1:Press the TEST key on the power board to enter the (PULL DOWN MODE), the door display panel displays T1 T1 and the refrigerator enters forced refrigeration state: the compressor operates normally, the fan runs at high speed, and the defrosting heating wire is disconnected. This can be used to test the refrigeration performance.

 

TEST2:Press TEST key again in TEST1 MODE to enter the (FORCED DEFROSTING MODE). It will act depending on the temperature sensed by the defrosting sensor When the temperature sensed by the defrosting sensor is over 10℃, the heating wire will exit the (FORCED DEFROSTING MODE)after 20s’ heating When the temperature sensed by the defrosting sensor is below 10℃, the heating wire will heat continuously until the temperature sensed by the sensor reaches 7℃ In the (FORCED DEFROSTING MODE), the door display panel displays T2 T2, the refrigerator conducts forced defrosting, the compressor and the fan are turned off, and the defrosting heating wire is turned on. At this moment, you can test the power of the defrosting heating wire and it should be 153±15W.

Content Feedback
* 1. Is this content useful ?
* 2. Please evaluate this content ?

3. Please give us some suggestion.

SUBMIT
Product guide

Need your product manual or software? You can find them here!
Repair request registration

One step,our door to door service standby.

DR. FIDO Live Chat


Your online customer care expert. Get your queries answered instantly.

9.00 AM to 9.00 PM
(Monday to Saturday)

Ask a question


Submit a question to our support team

Start now

Toll Free Hotline Number


0333 003 8122

0344 561 1234

Contact us


Submit a question to our support team

Start now

Hotline


0333 003 8122

0344 561 1234

European Hotlines