Aligning the appliance
The appliance should be placed on a flat and solid surface
1.Tilt the refrigerator slightly backwards
2.Set the feet to the desired level
Make sure the distance to the wall on the hinge sides is at least 5cm
3.The stability can be checked by alternately bumping on the diagonals. The lightly swaying should be the same in both directions. Otherwise the frame can warp: possible leaking door seals are the result. A low tendency to the rear facilitates the closing of the doors.
Fine tuning of the doors
If the doors are still not in one level after leveling the doors by the feet. This mismatch can be remedied by turning the hinge lifting shaft at the right bottom corner of refrigerating door with a spanner
-Clockwise turn lifting shaft with spanner to lower door height
-Antic lock wise turn lifting shaft with spanner to lift door height.
Do not adjust the hinge lifting shaft excessively to a height which might cause the shaft to leave its original locked position. (Adjustable height range:3mm)