Troubleshooting

1. Clean primary filter

To ensure good drying results, clean the primary filter before or after each cycle.

(1) Open the upper drum door (Fig. 10-6).

(2) Remove the primary filter from the machine (Fig. 10-7).

(3) Open the filter (Fig. 10-8).

(4) Use a wet towel to clean up the fluff and lint residuals on each mesh (Fig. 10-9).

2. Clean secondary filter

After drying, please clean the secondary filter each time.

(1) Open the door and take out the primary filter (Fig. 10-10).

(2)Hold the handle of the secondary filter with your left hand, move the secondary filter to the front of the machine, then move to the left, and finally remove the secondary filter upward (Fig. 10-11).

(3)Use a wet towel to clean up the fluff and lint residuals on the outer mesh; Then wipe the water droplets or water film on the mesh of the secondary filter with a dry rag to prevent affecting the drying effect (Fig. 10-12).

(4)Remove the plastic support on the back of the filter and then take out the filter sponge, gently tap the filter sponge, shake off the lint and lint residuals (Fig. 10-13). (This step does not need to be cleaned every time, it is recommended to clean at least once a month based on the usage.)

Caution:

•   If rinse the filter with water, make sure that the surface of the filter is dry or wiped dry before putting it back in place.

•  After cleaning, reinstall the secondary filter. If the filter is not installed properly, there will be an alarm code E61 on the display.

•  When cleaning the primary filter, clean the dust around the filter seal, drying door glass, drying air duct, and other corners.